Low Frequency Off grid
Pure Sine Wave Inverter
Volt Power Sinus 5000W 24V/230V
Charger Power 70Amp
Peak 15000 Watts
With function of automatic generator startup
4 Item Items
Warning: Last items in stock!
Inverter VOLT UPS POWERSINE-5000 is a device used mainly as a UPS with Pure Sine course of voltage. You can apply it anywhere where you need a stable voltage and very high inrush current 5000W in this transient (to 20 seconds) 15000W! An important advantage of this device is the ability to connect various types of batteries.
It is used as a UPS, a backup source of power for electrical appliances: for powering fans, pumps, central heating, computers, internet devices, home appliances, especially for appliances that need higher peak power.
It works bi-directionally: in one direction it converts DC power from the battery to AC power (Inverter Mode) and in the other direction it converts external AC power to DC power to charge the batteries (AC Mode). The same power components are used in both directions, resulting in high-energy transfer efficiency with fewer components.
When operating in invert mode, the direct current (DC) that enters the inverter from the batteries is filtered
by a large input capacitor and switched “On” and “Off” by the Metal Oxide Silicon Field Effect Transistors (MOSFET) at a rate of 50 Hz or 60Hz, in this step the DC is converted to low voltage synthesized sine wave AC using an H-bridge configuration and high frequency PWM (Pulse Width Modulation) technique.
It is then directed into the transformer which steps the low AC voltage up to 230 or 120 volts.
The unit has a 16bit, 4.9MHZ microprocessor to control the output voltage and frequency as the DC input voltage and/or output load varies.
Because of high efficiency MOSFETs and the heavy transformers, it outputs PURE SINE WAVE AC with low THD.
The peak efficiency of DP series is 88%.
You can connect solar panels, if you additionally use external solar regulator.
It can work with all types of generators.
Auto Gen Start (optional):
The inverter can be customized to start up a generator when battery voltage goes low.
When the inverter goes to low battery alarm, it can send a signal to start a generator, and turn the generator
off after battery charging is finished.
The auto gen start feature will only work with generators designed to work with this feature. There is an
open/close relay that will short circuit the positive and negative cable from a generator. The input DC
voltage can vary, but the Max current the relay can carry is 16Amp.
It has wide range of applications. You can use it for supply your home devices, camper van, motorboat etc.